Agilent Technologies Signal Analyzer N9030a - Manual (Page 1384)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Trace/Detector
Example TRAC3:DISP 1 Shows the reference trace.
Notes Use the TRAC3:DISP command to show or blank the reference trace
Trace 3 is always the reference trace by definition.
State Saved Saved in instrument state.
Initial S/W Revision Prior to A.02.00
Norm Ref Lvl
Sets the level (in dB) of the normalized reference.
Key Path Trace/Detector, Normalize
Remote Command :DISPlay:WINDow[1]:TRACe:Y[:SCALe]:NRLevel <rel_ampl>
:DISPlay:WINDow[1]:TRACe:Y[:SCALe]:NRLevel?
Example DISP:WIND:TRAC:Y:NRL .10 dB
DISP:WIND:TRAC:Y:NRL?
Preset 0 dB
State Saved Saved in instrument state.
Min –327.6 dB
Max 327.6 dB
Initial S/W Revision Prior to A.02.00
Open/Short Cal
Performs a guided open/short calibration, while providing step-by-step instructions to the user.
This is the most accurate way to make the return loss measurement on the X-series analyzers. You
are directed through a 1-Port coaxial open calibration, and a 1-Port coaxial short calibration. The
result can then be saved to Trace 3. It is used to perform calibrated scalar reflection
measurements (return loss), using the Normalize function.
Key Path Trace/Detector, Normalize
Mode SA
Notes Does not auto return
Dependencies Key is grayed out unless Source Mode is Tracking, and control returns to the Normalize menu.
Initial S/W Revision A.06.01
1384 Remote Language Compatibility Measurement Application Reference