Agilent Technologies Signal Analyzer N9030a - Manual (Page 606)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Input/Output
This is unaffected by Preset but is set to the default value on a "Restore Input/Output Defaults"
or "Restore System Defaults->All"
Range 50 Ω | 1 MΩ
Initial S/W Revision Prior to A.02.00
Q Skew
Sets the skew factor for the Q channel. The skew will shift the channel's data in time. Use this to
compensate for differences in the electrical lengths of the input paths due to cabling and probes.
Key Path Input/Output, I/Q, Q Setup
Remote Command [:SENSe]:CORRection:IQ:Q:SKEW <seconds>
[:SENSe]:CORRection:IQ:Q:SKEW?
Example Delay the data for the Q channel by 10 ns.
CORR:IQ:Q:SKEW 10 ns
Preset 0
State Saved Yes
This is unaffected by a Preset but is set to the default value on a "Restore Input/Output
Defaults" or "Restore System Defaults->All"
Range 0 s to 100 ns
Min 0 s
Max +100 ns
Initial S/W Revision Prior to A.02.00
Q Probe
Accesses the probe setup parameters for the Q channel. See "I/Q Probe Setup" on page 611 .
Key Path Input/Output, I/Q, Q Setup
State Saved No
Readback Text [<Q port probe id>]
This is reporting the type of probe sensed on the Q port. There is no parameter for overriding
what is sensed.
Initial S/W Revision Prior to A.02.00
606 Remote Language Compatibility Measurement Application Reference