Agilent Technologies Signal Analyzer N9030a - Manual (Page 202)

4 List of Legacy Analyzer Commands
Alphanumeric List of all Legacy Commands with N9061A Support
Command Description 8566 8568
8560
Series Description
SYNCMODE Synchronize mode N/A N/A N/A
T0 Turns the threshold level
off No No N/A
T1 Sets the trigger mode to
free run Yes Yes Yes "T1 [one] (Free Run Trigger)" on page 477
T2 Sets the trigger mode to
line Yes Yes Yes "T2 [two] (Line Trigger)" on page 478
T3 Sets the trigger mode to
external Yes Yes Yes "T3 [three] (External Trigger)" on page 479
T4 Sets the trigger mode to
video Yes Yes Yes "T4 [four] (Video Trigger)" on page 480
T7 Sets the trigger mode to
level No No N/A
T8 Sets the trigger mode to
edge No No N/A
TA Returns trace A amplitude
values to controller Yes Yes Yes "TA (Trace A)" on page 481
TB Returns trace B amplitude
values to controller Yes Yes Yes "TB (Trace B)" on page 482
TDF Trace data format Yes Yes Yes "TDF (Trace Data Format)" on page 483
TEXT Writes text on the analyzer
screen No No No
TH Threshold Yes Yes Yes "TH (Threshold)" on page 484
THE Turns the threshold on or
off Yes Yes N/A "THE (Threshold Enable)" on page 486
THEN Conditional Programming
(If…then…else…endif) No No No
TIMEDATE Allows setting of time &
date for analyzer N/A N/A Yes "TIMEDATE (Time Date)" on page 487
TIMEDSP Enables display of time &
data on analyzer display N/A N/A N/A
TITLE Title entry N/A N/A Yes "TITLE (Title)" on page 488
TM Trigger Mode Yes Yes Yes "TM (Trigger Mode)" on page 489
TOI Third order intermodulation
measurement N/A N/A N/A
202 Remote Language Compatibility Measurement Application Reference