Agilent Technologies Signal Analyzer N9030a - Manual (Page 576)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
FREQ Channel
Option when turn TG
on and can’t
tune below
while TG on) clipped to this
Freq when TG
turned on above) while TG
on
T03 9 kHz 3.0 GHz 3.08 GHz
T06 9 kHz 6.0 GHz 6.05 GHz
The following table shows the Center Frequency Presets for modes other than Spectrum Analyzer:
Mode CF Preset for RF
WCDMA 1 GHz
WIMAXOFDMA, 1 GHz
BASIC 1 GHz
ADEMOD 1 GHz
VSA 1 GHz
TDSCDMA 1 GHz
PNOISE 1 GHz
LTE 1 GHz
LTETDD 1 GHz
MSR 1 GHz
GSM 935.2 MHz
NFIGURE 1.505 GHz
RF Center Freq
SCPI command for specifying the RF Center Frequency. This command will set the Center
Frequency to be used when the RF input is selected, even if the RF input is not the input that is
selected at the time the command is sent. Note that the Center Freq function in the Frequency menu
on the front panel always applies to the currently selected input.
Scope Meas Global
Remote Command [:SENSe]:FREQuency:RF:CENTer <freq>
[:SENSe]:FREQuency:RF:CENTer?
Example FREQ:RF:CENT 30 MHz
Notes This command is the same in all modes, but the parameter is Measurement Global. So the value
576 Remote Language Compatibility Measurement Application Reference