Agilent Technologies Signal Analyzer N9030a - Manual (Page 165)

3 Programming the Analyzer
STATus Subsystem
register bit has a positive transition (0 to 1). The variable <integer> is the sum of the decimal
values of the bits that you want to enable.
Mode All
Remote
Command :STATus:QUEStionable:INTegrity:SIGNal:PTRansition <integer>
:STATus:QUEStionable:INTegrity:SIGNal:PTRansition?
Example STAT:QUES:INT:SIGN:PTR 4
Burst not found will be reported to the Integrity Summary of the Status Questionable register.
Preset 32767
Min 0
Max 32767
Status
Bits/OPC
dependencies Sequential command
Initial S/W
Revision Prior to A.02.00
Questionable Integrity Uncalibrated Register
The following commands and queries are available for this register:
"Questionable Integrity Uncalibrated Condition" on page 165
"Questionable Integrity Uncalibrated Enable" on page 166
"Questionable Integrity Uncalibrated Event Query" on page 166
"Questionable Integrity Uncalibrated Negative Transition" on page 167
"Questionable Integrity Uncalibrated Positive Transition" on page 167
Questionable Integrity Uncalibrated Condition
This query returns the decimal value of the sum of the bits in the Questionable Integrity
Uncalibrated Condition register.
The data in this register is continuously updated and reflects the current conditions.
Mode All
Remote Command :STATus:QUEStionable:INTegrity:UNCalibrated:CONDition?
Example STAT:QUES:INT:UNC:COND?
Remote Language Compatibility Measurement Application Reference 165