Next pk left, Marker delta, Mkr->cf – Agilent Technologies Signal Analyzer N9030a User Manual
Page 897
6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Peak Search
Next Pk Left
Pressing Next Pk Left moves the selected marker to the nearest peak left of the current marker that
meets all enabled peak criteria. If there is no valid peak to the left of the current marker position,
a “No peak found” message is generated and the marker is not moved.
If the selected marker was off, then it is turned on as a normal marker and a peak search is
performed.
Key Path
Peak Search
Remote Command
:CALCulate:MARKer[1]|2|...12:MAXimum:LEFT
Example
CALC:MARK2:MAX:LEFT selects marker 2 and moves it to the next peak to the left of the current
marker position.
State Saved
Not part of saved state.
Initial S/W Revision
Prior to A.02.00
Marker Delta
Performs the same function as the Delta 1-of-N selection key in the Marker menu. Basically this
sets the control mode for the selected marker to Delta mode. See the Section “
” for the complete description of this function. The key is duplicated here in the Peak Search
Menu to allow you to conveniently perform a peak search and change the marker’s control mode
to Delta without having to access two separate menus.
Key Path
Peak Search or Marker
Notes
Whenever the selected marker is in Delta mode and you are in the Peak Search menu, the
Marker Delta key should be highlighted and the active function for setting its delta value turned
on.
Initial S/W Revision
Prior to A.02.00
Mkr->CF
Assigns the selected marker’s frequency to the Center Frequency setting. See the Section “
” for the description of this function. The key is duplicated here in the Peak
Search Menu to allow you to conveniently perform a peak search and marker to CF without
having to access two separate menus.
Key Path
Peak Search or Marker ->
Remote Language Compatibility Measurement Application Reference
897