Agilent Technologies Signal Analyzer N9030a - Manual (Page 797)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Meas Setup
:CALCulate:LLINe[1]|2|...6:DISPlay?
Example :CALC:LLIN2:DISP ON turns on the display for limit line 2.
Dependencies This command will generate an “Option not available” error message unless you have the proper
option installed in your instrument.
Couplings Limit display ON selects the limit.
Testing is done on all displayed limits if Test Limits (All Limits) is ON.
Entering the limit menu from the GUI turns on the selected limit.
Preset OFF
State Saved Saved in instrument state.
Backwards
Compatibility SCPI :CALCulate:LLINe[1]|2:STATe OFF|ON|0|1
In the past you had to send the DISP command as well as the STATe command in order to get a
limit on and testing. Now, the DISP command is sufficient, but we accept the state command
and map it to DISP
Initial S/W Revision A.02.00
Properties
Accesses a menu which lets you set the properties of the selected limit.
Key Path Meas Setup, Limits
Initial S/W Revision A.02.00
Select Limit
Specifies the selected limit. The term “selected limit” is used throughout this document to specify
which limit will be affected by the functions.
Key Path Meas Setup, Limits, Properties
Notes The selected limit is remembered even when not in the Limit Menu.
Preset Limit 1, not affected by Mode Preset, preset by Restore Mode Defaults.
State Saved Saved in instrument state.
Initial S/W Revision A.02.00
Remote Language Compatibility Measurement Application Reference 797