Agilent Technologies Signal Analyzer N9030a - Manual (Page 1447)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
View/Display
Key Path View/Display, Display, Annotation
Remote Command :DISPlay:ACTivefunc[:STATe] ON|OFF|1|0
:DISPlay:ACTivefunc[:STATe]?
Example DISP:ACT OFF
Dependencies Grayed out and forced to OFF when System Display Settings, Annotation is set to Off.
Preset On
This should remain Off through a Preset when System DisplaySettings, Annotation is set to Off
State Saved Saved in instrument state.
Initial S/W Revision Prior to A.02.00
Title
Displays menu keys that enable you to change or clear a title on your display.
Key Path View/Display, Display
Initial S/W Revision Prior to A.02.00
Change Title
Writes a title into the "measurement name" field in the banner, for example, "Swept SA".
Press Change Title to enter a new title through the alpha editor. Press Enter or Return to complete
the entry. Press ESC to cancel the entry and preserve your existing title.
The display title will replace the measurement name. It remains for this measurement until you
press Change Title again, or you recall a state, or a Preset is performed. A title can also be cleared
by pressing Title, Clear Title.
Notice the inclusion of the <measurement> parameter in the command below. Because each
measurement remembers the Display Title, the command must be qualified with the measurement name.
For the Swept SA measurement this is not the case; no <measurement> parameter is used when
changing the Display Title for the Swept SA measurement.
Key Path View/Display, Display, Title
Mode All
Remote Command :DISPlay:<measurement>:ANNotation:TITLe:DATA <string>
:DISPlay:<measurement>:ANNotation:TITLe:DATA?
Remote Language Compatibility Measurement Application Reference 1447