Agilent Technologies Signal Analyzer N9030a - Manual (Page 167)

3 Programming the Analyzer
STATus Subsystem
Preset 0
Status Bits/OPC dependencies Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Integrity Uncalibrated Negative Transition
This command determines which bits in the Questionable Integrity Uncalibrated Condition
register will set the corresponding bit in the Questionable Integrity Uncalibrated Event register
when the condition register bit has a negative transition (1 to 0). The variable <integer> is the
sum of the decimal values of the bits that you want to enable.
Mode All
Remote
Command :STATus:QUEStionable:INTegrity:UNCalibrated:NTRansition <integer>
:STATus:QUEStionable:INTegrity:UNCalibrated:NTRansition?
Example STAT:QUES:INT:UNC:NTR 1
Oversweep cleared will be reported to the Integrity Summary of the Status Questionable register.
Preset 0
Min 0
Max 32767
Status
Bits/OPC
dependencies Sequential command
Initial S/W
Revision Prior to A.02.00
Questionable Integrity Uncalibrated Positive Transition
This command determines which bits in the Questionable Integrity Uncalibrated Condition
register will set the corresponding bit in the Questionable Integrity Uncalibrated Event register
when the condition register bit has a positive transition (0 to 1). The variable <integer> is the
sum of the decimal values of the bits that you want to enable.
Mode All
Remote
Command :STATus:QUEStionable:INTegrity:UNCalibrated:PTRansition <integer>
:STATus:QUEStionable:INTegrity:UNCalibrated:PTRansition?
Example STAT:QUES:INT:UNC:PTR 1
Oversweep (Meas Uncal) occurred will be reported to the Integrity Summary of the Status Questionable
Remote Language Compatibility Measurement Application Reference 167