Lenze EDS4900U-REG - Manual (Page 210)

Configuration
7-119
48XX/49XXSHB0399
7.9 Code table
How to read the code table:
Column Abbreviation Meaning
Code C013 Code C013
l The parameter value is accepted immediately (ONLINE).
C009* l Code of the extended code set
C001 ¤ l The parameter value of the code will be accepted after pressing SH+ PRG.
[C002] l The parameter value of the code will be accepted after pressing SH+ PRG,
but only if the controller is inhibited.
Name Name of the code
Lenze Factory setting of the code
Selection 1 {1 %} 99 Minimum value {smallest step/unit} maximum value
Info - Additional, important explanation of the code
Code Name Possible settings Code Name
Lenze Selection Info
C000 ¤ Code set 1 -0- (+ PW) Standard code set read only Can only be changed via keypad!
If a password is defined under C094, a
-1- (+ PW) Standard code set
If a password is defined under C094, a
change from -0- to -1- or -2- is only
possible after entering this password
-2- (+ PW) Extendend code set
possible after entering this password
(+ PW):
1 Change C000 acknowledge with
SH
-9- For service only
1. Change C000, acknowledge with SH +
PRG .
2 P d tti ith ▲
-11- Code set for automation module
2. Password setting with ▲ or ▼.
3. Accept with SH + PRG.
[C001] Operating mode 0 Control Parameter setting
-0- Terminals Keypad
-1- Keypad Keypad
-2- Terminals LECOM1
-3- LECOM1 LECOM1
-4- Terminals LECOM2 (*)
-5- LECOM2 (*) LECOM2 (*)
-6- LECOM2 (*) Keypad
-7- LECOM2 (*) LECOM1
(*) Fieldbus
With C001 =
-2-, -3-, -4-, -5-, -7-, TRIP must be reset
(C043) via the interface or the terminal.
With LECOM2, TRIP reset is also possible
via the control word of the process data
channel.
[C002] Load parameter
set 0 -0- Factory setting
-1- Parameter set 1
-2- Parameter set 2
-3- Parameter set 3
-4- Parameter set 4
Parameter set 1 is automatically loaded
after mains connection. If another
parameter set is selected via terminal, this
parameter set will also be loaded.
C003 ¤ Save parameter
set
1 -1- Parameter set 1
-2- Parameter set 2
-3- Parameter set 3
-4- Parameter set 4
C004 ¤ Switch-on
display
83 0 {1} 999 Code No. for switch-on display: Can only
be changed if C001= -0-, -1-, -6-
Show/Hide Bookmarks