Lenze EDS4900U-REG - Manual (Page 266)

Automation
12-6 48XX/49XXSHB0399
C392 field current set-value
Note!
The field current cannot be reduced more than to the minimum field current set
under C231. If the controller is in field-weakening operation, this range cannot be
left by setting a higher field current set-value.
Display of the field current set-value.The figure 2 14 = 16384 corresponds to 100%
of the rated value under C083. The field current set-vlaue can be assigned to a
process input word so that the set-value can be controlled via the fieldbus system.
C393 additional set-value
Display of the additional set-value for the speed controller. The figure 2 14 = 16384
corresponds to 100% of the maximum additional set-value. The information is the
same as under C049.
Code Name Possible settings Code Name
Lenze Selection Info
C380* n
set
speed -16384 {1} 16384 High precision set-value input:
16384
Ÿ 100%under C046
Input only via interface
C381* n
set
at
n controller
-32767 {1} 32767 High precision set-value display:
Input of the speed controller
16384
Ÿ 100%under C050.
Input only via interface.
C382* Actual
speed -32767 {1} 32767 High precision display: actual speed value
16384
Ÿ n
max
under C011.
Input only via interface.
C387* Torque limit -16384 {1} 16384 High precision torque set-value input:
16384
Ÿ 100%under C047.
Input only via interface.
C388* Torque
setpoint -16384 {1} 16384 High precision torque set-value display:
16384
Ÿ 100%under C056.
Input only via interface.
C391* Actual
phase 0 {1} 65535 High precision display of the actual phase
value if resolver or incrmental encoder
operate as feedback system:
16384
Ÿ 360• Ÿ 1 revolution
Input only via interface.
C392* Field
current
set-value 0 {1} 16384 High precision display of the field current
set-value:
16384
Ÿ I
Frated
under C083.
Input only via interface.
C393* Additional
set-value -16384 {1} 16384 High precision additional set-value display:
16384
Ÿ 100%under C049.
Display only via interface.
Show/Hide Bookmarks