Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 123)

L-force | PLC Designer
The Individual Components

DMS 3.2 EN 02/2011 TD29 121
If option 'Symbol config from INI-file' is not activated, the symbol entries will be
generated in accordance with the settings you can make in the 'Set object attributes'
dialog. You get there using the Configure symbol file button:
Dialog 'Set object attributes' (in option category Symbol configuration)
Use the tree-structured selection editor to mark the variables which should be entered
in the symbol file. For this purpose you can select a POU's entry (e.g. Global Variables)
which automatically will mark all variables belonging to this POU, or you can select
particular variables. For the selected set of entries then activate the desired options in
the lower part of the dialog box by mouse-clicks on the corresponding option boxes.
Activated options are displayed checked. The following options can be set:
Export variables of object: The variables of the selected object are exported into the
symbol file.
The following options can take effect only if the Export variables of object option is
activated:
• Export data entries: Entries for access to the global variables are created for
object's structures and arrays.
• Export structure components: An individual entry is created for each variable
component of object's structures.
• Export array entries: An individual entry is created for each variable component of
object's arrays.
• Write Access: Object's variables may be changed by the OPC server.