Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 304)

L-force | PLC Designer
Editors in PLC Designer
302 DMS 3.2 EN 02/2011 TD29

Open instance
This command corresponds to the 'Project' 'Open instance' command.
It is available in the context menu (<F2>) or in the 'Extras' menu, if the cursor is
positioned on the name of a function block in a text editor or if the function block box
is selected in a graphic editor.
Cutting, Copying, Pasting, and Deleting in FBD
The commands used to 'Cut', 'Copy', 'Paste', and 'Delete' are found under the 'Edit'
menu item.
If a line cross is selected (Cursor Position 5) (see 'Cursor positions in FBD'), then the
assignments, jumps, or RETURNS located below the crossed line will be cut, deleted, or
copied.
If a POU is selected (Cursor Position 3), then the selected object itself, will be cut,
deleted, or copied, along with all of the branches dependent on the inputs, with the
exception of the first (highest position) branch.
Otherwise, the entire branch located in front of the cursor position will be cut,
deleted, or copied.
After copying or cutting, the deleted or copied part is located on the clipboard and can
now be pasted, as desired.
In order to do so, you must first select the pasting point. Valid pasting points include
inputs and outputs.
If a POU has been loaded onto the clipboard (As a reminder: in this case all connected
branches except the first are located together on the clipboard), the first input is
connected with the branch before the pasting point.
Otherwise, the entire branch located in front of the pasting point will be replaced by
the contents of the clipboard.