Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 712)

L-force | PLC Designer
PLC Designer Visualization
710 DMS 3.2 EN 02/2011 TD29

20.6.12 Motion relative
In the dialog for configuring visualization elements in the Motion Relative category,
you can assign variables to the individual element edges. Depending on the values of
the variables, the corresponding element edges are then moved. The easiest way to
enter variables into the fields is to use the Input Assistant (<F2>).
The four entries indicate the four sides of your element. The base position of the
corners is always at zero. A new value in the variables, in the corresponding column,
shifts the boundary in pixels around this value. Therefore, the variables that are
entered ought to be INT variables.
Note!
Positive values shift the horizontal edges downward, or, the vertical edges, to the
right!
In online mode the variables which are set in the 'Motion absolute' dialog will
override the values of structure components which additionally might be used to
define the same property ('Programmability').
In case of multiple definition of an element property consider the specific order of
precedence concerning according to which a value might be overwritten in online
mode by another.
Dialog Box for Configuration of Visualization Elements (Motion Relative Category)