Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 267)

L-force | PLC Designer
Editors in PLC Designer

DMS 3.2 EN 02/2011 TD29 265
Sorting the declarations:
In order to sort the table entries, set the cursor to the line number bar at the left
border of the editor window and choose one of the following commands in the
context menu:
• Sort by name: All lines are sorted alphabetically according to the identifier names
in column ‘Name’.
• Sort by address: All lines are sorted alphabetically according to the address entries
in column ‘Address’.
• Sort by type: All lines are sorted alphabetically according to the type names in
column ’Type’.
• Original order: The lines are displayed in the order in which they had been entered
originally.
Declaration Editor as a Table
7.2.21 'Insert' 'New Declaration'
With this command you bring a new variable into the declaration table of the
declaration editor. If the present cursor position is located in an field of the table, then
the new variable will be pasted in the preceding line; otherwise, the new variable is
pasted at the end of the table. Moreover, you can paste a new declaration at the end
of the table by using the right arrow key or the tab key in the last field of the table.
You will receive a variable that has "Name" located in the Name field, and "Bool"
located in the Type field, as its default setting. You should change these values to the
desired values. Name and type are all that is necessary for a complete declaration of
variables.