Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 318)

L-force | PLC Designer
Editors in PLC Designer
316 DMS 3.2 EN 02/2011 TD29

'Insert' 'Jump'
'This command inserts a jump in the SFC editor at the end of the branch, to which the
marked block belongs. For this the branch must be an alternative branch.
The inserted text string 'Step' in the inserted jump can then be selected and replaced
by the step name or the jump label of a parallel branch to be jumped to.
Concerning the step name please see 'Insert' 'Step Transition (before)'.
'Insert' 'Transition-Jump'
Symbol:
This command inserts a transition in the SFC editor, followed by a jump at the end of
the selected branch. For this the branch must be a parallel branch.
The inserted text string 'Step' in the inserted jump can then be selected and replaced
by the step name or the jump label of a parallel branch to be jumped to.
Concerning step name and transition name please see 'Insert' 'Step Transition
(before)'.
'Insert' 'Add Entry-Action'
With this command you can add an entry action to a step. An entry-action is only
executed once, right after the step has become active. The entry-action can be
implemented in a language of your choice.
A step with an entry-action is designated by an "E" in the bottom left corner.
'Insert' 'Add Exit-Action'
With this command you can add an exit-action to a step. An exit-action is only
executed once, before the step is deactivated. The exit-action can be implemented in a
language of your choice.
A step with an exit-action is designated by an "X" in the lower right corner.
'Extras' 'Paste Parallel Branch (right)'
This command pastes the contents of the clipboard as a right parallel branch of the
marked block. For this the marked block must both begin and end with a step. The
contents of the clipboard must, likewise, be an SFC block that both begins and ends
with a step.