Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 595)

L-force | PLC Designer
Compiler Errors and Warnings

DMS 3.2 EN 02/2011 TD29 593
3564
"The external event '<name>' of task '<name>' is not supported by the current target"
The currently set target system does not support the external event which is defined
in the task configuration for this task. Change target or modify the task configuration
correspondingly.
3565
"Maximum number of event tasks ('<number>') exceeded"
The currently set target system does not allow as many event tasks as are defined at
the moment. Change target or modify the task configuration correspondingly.
3566
"Maximum number of interval tasks ('<number>') exceeded"
The currently set target system does not allow as many interval tasks as defined at the
moment. Change target or modify the configuration correspondingly.
3567
"Maximum number of free wheeling tasks ('<number>') exceeded"
The currently set target system does not allow as many free wheeling tasks as defined
at the moment. Change target or modify the configuration correspondingly.
3568
"Maximum number of external interval tasks ('<number>') exceeded"
The currently set target system does not allow as many external interval tasks as
defined at the moment. Change target or modify the configuration correspondingly.
3569
"POU '<name>' for system event '<name>' not defined"
The POU which should be called by the named system event, as defined in the task
configuration, is not available in the project. Modify the task configuration
correspondingly or make sure that the POU is available in the project.
3570
"The tasks '<name>' and '<name>' share the same priority"
Modify the task configuration so that each task has a different priority.