Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 295)

L-force | PLC Designer
Editors in PLC Designer

DMS 3.2 EN 02/2011 TD29 293
Set Contact Comment to Symbol Comment: If this option is activated, in the comment
field of a contact resp. a coil that comment will be displayed which has been defined
at the declaration of the variable used for the contact or coil. The comment then can
be edited. (see example in the subsequent picture.). For this purpose however the
option 'Comments per Contact' also must be activated. Regard that a comment which
has been entered already locally at a contact or coil will be replaced automatically by
the variable comment in any case, even if the variable has not got a comment in its
declaration!
Show Address of Symbol: (only for Ladder editor): If this option is activated and a
variable assigned to a contact or coil is assigned to an address, the address will be
displayed above the variable name (see example in the picture above).
Show Variable Comments per Rung in Printout: If this option is activated, in each
network for each variable used in that network there will be displayed a line showing
the name, address, data type and comment for this variable, as defined in the
variables declaration. This might be of useful for a documentation (printout) of the
project. Example:
Applying the options:
OK: Press this button to apply the settings on the actual POU and to close the options
dialog.
Apply options: Press this button to apply the settings on the whole project. A dialog
will open asking you where you have explicitly to confirm that you want to do that.