Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 436)

L-force | PLC Designer
The Resources
434 DMS 3.2 EN 02/2011 TD29

8.11.1 Activating the Parameter Manager
The Parameter Manager must be activated In the Resources tab in »PLC Designer«
open the Target Settings, category Networkfunctionality. Here also the Index- and
Subindex ranges for the entries in the parameter lists of type 'Parameter' (constants),
'Variables' (project variables) and - if supported by the target system - Mappings (for
CAN Device PDOs) must be defined. It depends on the target system whether these
settings are visible resp. editable for the user.