Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 164)

L-force | PLC Designer
The Individual Components
162 DMS 3.2 EN 02/2011 TD29

If it is not a editor POU, but the task configuration, the target settings etc., then the
POU version of the actual and the reference project can be opened in separate
windows by a double click on the respective line in the project structure. For those
project POUs no further details of differences will be displayed.
6.3.28 Working in the compare mode
If the cursor is placed on a line in the bipartited window, which indicates a difference,
the menu 'Extras' resp. The context menu offers a selection of the following
commands, depending on whether working in the project overview or in a POU.
• 'Next difference'
• 'Previous difference'
• 'Accept change'
• 'Accept changed item'
• 'Accept properties'
• 'Accept access rights'
Note!
The acceptance of different project parts (differences) or access right properties is
only possible from the reference project of the actual project, not vice versa.
6.3.29 'Extras' 'Next difference'
Shortcut: <F7>
This command is available in the compare mode (see above 'Project' 'Compare').
The cursor jumps to the next unit, where a difference is indicated. (line in project
overview, line/network/element in POU)
6.3.30 'Extras' 'Previous difference'
Shortcut: <Shift><F7>
This command is available in the compare mode (see above 'Project' 'Compare').
The cursor jumps to the previous unit, where a difference is indicated . (line in project
overview, line/network/element in POU)