Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 173)

L-force | PLC Designer
The Individual Components

DMS 3.2 EN 02/2011 TD29 171
6.3.45 'Project' 'User group passwords'
With this command you open the dialog box for password assignment for user
groups. This command can only be executed by members of group 0. When the
command has been given, then the following dialog box appears:
Dialog box for password assignment
In the left combobox User group you can select the group. Enter the desired password
for the group in the field Password. For each typed character an asterisk (*) appears in
the field. You must repeat the same password in the field Confirm password. Close the
dialog box after each password entry with OK. If you get the message:
"The password does not agree with the confirmation",
then you made a typing error during one of the two entries. In this case repeat both
entries until the dialog box closes without a message.
Then, if necessary, assign a password for the next group by calling the command
again.
Note!
If passwords are not assigned to all user groups, a project can be opened by way of a
group to which no password was assigned!
Use the command 'Object' 'Access rights' to assign the rights for single objects or all of
them.
Concerning the protection of a project regard also the following:
• Passwords for access and write protection
• Encryption of a project at project saving