Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 25)

L-force | PLC Designer
Lenze specifications

DMS 3.2 EN 02/2011 TD29 23
2 Lenze specifications
The »PLC Designer« is based on the »CoDeSys« (Controller Development System) IEC
development environment of the company 3S - Smart Software Solutions GmbH,
Kempten.
In contrast to »CoDeSys« the »PLC Designer« does not support the following
functions/hardware:
• CanDevice (CANopen Slave)
• DeviceNet modules
• Encoder and sercos interfaces
• CoDeSys HMI
• CoDeSys Target-Visualization
2.1 Migration of the Lenze targets
In control technology, Lenze targets support the communication of the interlinked
field devices via the bus lines CANopen (Logic) and CANopen (Motion).
Information on establishing communication via the bus lines CANopen (Logic) and
CANopen (Motion) can be found in the " CANopen control technology"
communication manual.
2.1.1 Updating the Lenze target "V5 Logic" to "V6 Logic with Motion"
Step V5 Logic -> V6 Logic V5 Logic -> V6 Logic with Motion
1 Open the org. V5 project Open the org. V5 project
2 Set the "Save configuration files in project"
option Set the "Save configuration files in project"
option
3 Save project Save project
4 Select the V6 target under Target system
settings -> Configuration Select the V6 target under Target system
settings -> Configuration
5 Add the 3S_CANOpenMaster.lib function library
in the Library manager
Add the 3S_CANOpenMaster.lib function
library in the Library manager
6 Save and close project Save and close project
7 Open project Open project
8 Translate project completely Translate project completely