Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 577)

L-force | PLC Designer
Compiler Errors and Warnings

DMS 3.2 EN 02/2011 TD29 575
1803
"'<name>'('<number>'): "The print action would not supported for web- and target
visualisation"
An print action is assigned to an alarm configured in the visualization. This will not be
regarded in the Web- or Target-Visualization.
1804
"'<name>'('<number>'): The font '<name>' is not supported by the target."
In the visualization you are using a font, which is not supported by the target system.
See in the target settings, category 'Visualization' for the supported fonts.
1807
"<name> (<number>): No message window for alarms for target visualization"
Regard that action "message" is not supported for the Target-Visualization!
1808
"'<name>'('<number>'): A polygon consists of to many points for target visualization.
In case of a meter element, please open the configuration once."
Per default maximum 512 points are allowed, target-specifically another maximum
number might be defined. By opening the configuration dialog the element will be
optimized to the allowed number of points.
1809
"'<name> ('<nummer>'): Invalid visualization as zoom target: '<number>'"
This visualization could not be found. Please check whether the visualization name is
not correct or the visualization object is not available at all.
1850
"Input variable at %IB<number> is used in task '<name>' but updated in another task"
Please check which tasks are using this variable and whether the current
programming is not causing undesirable effects. The update of the variable value
usually is done in the task with the highest priority.
1851
"Output variable at %IQ<number> is used in task '<name>' but updated in another
task"
Please check which tasks are using this variable and whether the current
programming is not causing undesirable effects. The update of the variable value
usually is done in the task with the highest priority.