Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 160)

L-force | PLC Designer
The Individual Components
158 DMS 3.2 EN 02/2011 TD29

The version of the reference project can be accepted for single differences or for 'all
equally marked' differences. To accept means that the version of the reference project
is taken over to the actual project.
Please note: In compare mode (see status bar: COMPARE) the project cannot get
edited !
6.3.26 Execute comparison
After executing the command 'Project' 'Compare' the dialog Project Comparison
opens:
Dialog for Project Comparison
Insert the path of the reference project at Project to compare. Press button if you
want to use the standard dialog for opening a project. If you insert the name of the
actual project, the current version of the project will be compared with the version
which was saved last.
If the project is under source control in an ENI data base, then the local version can be
compared with the actual version found in the data base. For this activate option
Compare with ENI-Project.
The following options concerning the comparison can be activated:
Ignore whitespaces: There will be detected no differences which consist in a different
number of whitespaces.
Ignore comments: There will be detected no differences in comments.
Ignore properties: There will be detected no differences in object properties.