Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 125)

L-force | PLC Designer
The Individual Components

DMS 3.2 EN 02/2011 TD29 123
If the option is activated, then the data base functions (Check in, Get last version etc.)
will be available for handling the project POUs. Then some of the data base functions
will run automatically like defined in the options dialogs, and in the menu 'Project'
'Data Base Link' you will find the commands for calling the functions explicitly. Besides
that a tab 'Data base-connection' will be added in the dialog Properties, where you can
assign a POU to a particular data base category.
Connect new Objects with the following data base:
Here you set a default: If a new object is inserted in the project ('Project' 'Object' 'Add'),
then it will automatically get assigned to that object category which is defined here.
This assignment will be displayed in the object properties dialog ('Project' 'Object'
'Properties') and can be modified there later. The possible assignments:
Project: The POU will be stored in that data base folder which is defined in the dialog
ENI configuration/Project objects in the field 'Project name'.
Shared Objects: The POU will be stored in that data base folder which is defined in the
dialog ENI configuration/Shared objects in the field 'Project name'.
Local: The POU will not be managed in a ENI data base, but only will be stored locally
in the project.
Besides 'Project objects' and 'Shared objects' there is a third data base category
'Compile files' for such objects which are not created until the project has been
compiled. Therefore this category is not relevant for the current settings.
Ask for type of new objects: If this option is activated, then whenever a new object is
added to the project, the dialog 'Object' 'Properties' will open, where you can choose
to which of the three object categories mentioned above the POU should be assigned.
By doing so the standard setting can be overwritten.