Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 752)

L-force | PLC Designer
PLC Designer Visualization
750 DMS 3.2 EN 02/2011 TD29

Category Columns:
Dialog for configuration of an alarm table, category 'Columns'
Define here, which of the columns (alarm parameters) should be displayed in the
alarm table: The parameters are defined -- except for date and time (alarm is coming)
and alarm state (see chapter 'Overview on Alarms') in the Configuration of the alarm
groups: Bitmap, Date, Time, Expression, Value, Message, Priority, Type, Class, State,
Target value (for alarm types DEV+ and DEV-), Deadband.
Using the buttons ">", ">>", you can take single resp. all parameters from the left to
the right window. The selection defined in the right window will be displayed in the
alarm table. Using the buttons "<" resp. "<<" entries can be removed from the
selection.
For each column you can open the dialog 'Configure columns' by a double-click on the
entry in the right window. In this dialog Column header and Column width can be
defined.