Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 350)

L-force | PLC Designer
The Resources
348 DMS 3.2 EN 02/2011 TD29

After the final customization by the user a binary image of the configuration is sent to
the PLC:
Example PLC Configuration with a CPU Module and a CAN Module
The PLC Configuration is displayed in the editor in tree structure and can be edited
using menu commands and dialogs. The configuration contains input and/or output
elements and also management elements which themselves also have subelements
(for example, a CAN-bus or a digital input card with 8 inputs).
For inputs and outputs, symbolic names can be assigned. The IEC-address where this
input or output can be accessed is then located behind the symbolic name.
Possibly the currently used target system defines that the CoDeSys V2.1 PLC
Configuration is to be used. In this case for help on working with the PLC
Configuration see the user documentation on CoDeSys V2.1, but regard the following
extensions in the configurator:
CAN configurator: Option "Create all SDO's" in dialog 'CAN Parameters' of a CAN module.
Attention: The SDO's now are always created according to the mechanism
used in the V2.3 configurator; thus the results may differ from that you got
previously.
Edit field "Device-Type" in dialog 'CAN settings' of a CanDevice.
Profibus configurator: The selection list of the Profibus modules available for getting inserted now
is sorted alphabetically by module names.