Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 633)

L-force | PLC Designer
Compiler Errors and Warnings

DMS 3.2 EN 02/2011 TD29 631
4555
"Empty table-entry, input not optional: Parameter OD <number>, Line <line number>
You must make an entry in this field.
4556
"Empty table-entry, input not optional: Variable OD <number>, Line <number>"
You must make an entry in this field.
4557
"The required parameter memory is too large"
The maximum size of data which can be loaded via parameter lists of type Parameters
to the controller has been exceeded. This size is defined by the target system.
Information on the data size is displayed in the message window at compilation.
Reduce the parameter lists size.
4558
"The required variable memory is too large"
The maximum size of data which can be loaded via parameter lists of type Variables
to the controller has been exceeded. This size is defined by the target system.
Information on the data size is displayed in the message window at compilation.
Reduce the parameter lists size.
4560
"Invalid value: Dictionary '<Name>', column '<Name>', line '<line number>'"
Check this entry. It depends on the currently used column (attribute) definition which
entries are valid for this field. This definition is given by the target-specific XML
description file of the Parameter Manager resp. by the standard settings which will be
used if there is no description file.
4561
"Column not defined: '<Name>'"
Entries in a column of the parameter list refer to another column, which is not defined
however. The column definitions are given by the description file (XML) of the
Parameter Manager for the current target. If a description file is not available,
standard settings are used.