Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 317)

L-force | PLC Designer
Editors in PLC Designer

DMS 3.2 EN 02/2011 TD29 315
Delete Step and Transition
A step can only be deleted together with the preceeding or the succeeding transition.
For this purpose put a selection frame around step and transition and choose
command 'Edit' 'Delete' or press the <Del> key.
'Insert' 'Alternative Branch (right)'
Symbol: Shortcut: <Ctrl>+<A>
This command inserts an alternative branch in the SFC editor as a right branch of the
marked block. For this the marked block must both begin and end with a transition.
The new branch is then made up of one transition.
'Insert' 'Alternative Branch (left)'
Symbol:
This command inserts an alternative branch in the SFC editor as the left branch of the
marked block. For this the marked block must both begin and end with a transition.
The new branch is then made up of one transition.
'Insert' 'Parallel Branch (right)'
Symbol: Shortcut: <Ctrl>+<L>
This command inserts a parallel branch in the SFC editor as the right branch of the
marked block. For this the marked block must both begin and end with a step. The
new branch is then made up of one step. To allow jumps to the parallel branches that
have been created, these must be provided with a jump label.
'Insert' 'Parallel Branch (left)'
Symbol:
'This command inserts a parallel branch in the SFC editor as the left branch of the
marked block. For this the marked block must both begin and end with a step. The
new branch is then made up of one step. To allow jumps to the parallel branches that
have been created, these must be provided with a jump label (see 'Extras' 'Add label to
parallel branch').