Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 768)

L-force | PLC Designer
PLC Designer Visualization
766 DMS 3.2 EN 02/2011 TD29

Command The equivalent in the
programming version
of »PLC Designer« Explanation
TRACE 1)2) Resources, Sampling Trace The window for trace recording
(Sampling Trace) will be opened.
The menu commands Trace Start,
Read, Stop, Save, Load which are
available in the full version of
»PLC Designer« are available in
this window.
CAM 1)2) Resources, CAMs If there is a CAMs definition
available in the project
(Resources), the CAM-Editor will
be opened.
As soon as the editor will be
closed again, it will be returned
to the visualization.
CNC 1)2) Resources, CNC program list f there is a CNC program list
available in the project
(Resources), the CNC editor will
be opened.
As soon as the CNC editor will be
closed again, it will be returned
to the visualization.
1 ) not supported for Target-Visualization
2) not supported for Web-Visualization
only for usage in a Web- or Target-Visualization:
The following commands can be used to give the write access in online mode on a visualization to a
certain client. This is of interest if multiple clients at the same time might modify data on the PLC.
REQUESTWRITEACCESS Request for write access
RELEASEWRITEACCESS Deallocation of the write access which has been
requested before
GLOBALRELEASEWRITEACCESS Global deallocation of the write access
only for usage in a Web-Visualization:
INTERN LINK <URL> The Web-Visualization will switch over within the
browser to the defined URL (Unified resource
location); e.g.."INTERN LINK http://www.3s-
software.com"
INTERN LINK <HTTP file path> The defined file will be opened; e.g. "INTERN LINK
http://localhost:8080/test.pdf"
INTERN LINK mailto:<EMail-Address> The entry mask for sending an EMail to the defined
address will be opened; e.g. " INTERN LINK
mailto:[email protected]"