Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 165)

L-force | PLC Designer
The Individual Components

DMS 3.2 EN 02/2011 TD29 163
6.3.31 'Extras' 'Accept change'
Shortcut: <Space>
This command is available in the compare mode (see above 'Project' 'Compare').
For all units, which are cohering with that one where the cursor currently is placed,
and which have the same sort of difference marking, (e.g. subsequent lines), the
version of the reference project will be accepted for the actual project (only possible in
this direction!). The corresponding units will be shown (with the corresponding
coloring) in the left side of the window.
For accepting changes of particular units please use 'Accept changed item'.
Note!
The acceptance of different project parts (differences) or access right properties is
only possible from the reference project of the actual project, not vice versa.
6.3.32 'Extras' 'Accept changed item'
Shortcut: <Ctrl> <Spacebar>
This command is available in the compare mode (see above 'Project' 'Compare').
Only the single unit (line, network, element) where the cursor is currently placed, will
be accepted for the actual version. The corresponding units will be shown (with the
corresponding coloring) in the left side of the window.
If for a POU, which has got marked red-colored in the structure tree because of a
change of its content, this change gets accepted, then the POU will be indicated by
yellow coloring in the actual project.
POUs which are only available in the current project because of 'Accept changed item',
also will be indicated by yellow coloring. POUs which have been removed from the
current project because of 'Accept changed item', will be indicated by yellow coloring
in the reference project.
Note!
The acceptance of different project parts (differences) or access right properties is
only possible from the reference project of the actual project, not vice versa.