Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 204)

L-force | PLC Designer
The Individual Components
202 DMS 3.2 EN 02/2011 TD29

Get All Latest Versions
Command 'Project' 'Data Base Link' 'Get All Latest Versions'
The latest version of each object of the currently opened project, which is kept under
source control, will be called from the data base. Consider the following:
• If in the meantime additional objects have been stored to the data base project
folder, then those will now be added to the local project in »PLC Designer«.
• If objects have been deleted in the data base in the meantime, those will not be
deleted in the local project, but they will automatically get assigned to category
'Local'.
• The latest version of objects of category 'Shared Objects' will only be called, if
these objects are already available in the local project. For further information see
command 'Get latest version'.
Multiple Check Out
Command 'Project' 'Data Base Link' 'Multiple Check Out'
You can check out several objects at a single blow. For this the dialog 'ENI-Selection'
will open, listing all POUs of the project. Select those which should be checked out and
confirm with OK. For further information see command 'Check Out'.
Multiple Check In
Command 'Project' 'Data Base Link' 'Multiple Check In'
You can check in several objects at a single blow. For this the dialog 'ENI-Selection' will
open, listing all POUs of the project. Select those which should be checked in and
confirm with OK. For further information see command 'Check In'.
Multiple Undo Check Out
Command 'Project' 'Data Base Link' Undo Multiple Check Out'
You can undo the check out action for several objects at a single blow. For this the
dialog 'ENI-Selection' will open, listing all POUs of the project. Select those for which
you want to cancel the check out and confirm with OK. For further information see
command 'Undo Check Out'.