Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 310)

L-force | PLC Designer
Editors in PLC Designer
308 DMS 3.2 EN 02/2011 TD29

'Insert' 'Parallel Contact' in LD
Symbol: Shortcut: <Ctrl>+<R>
Use this command in the LD editor to insert a contact parallel to the marked position
in the network.
If the marked position is a coil or the connection between the contacts and the coils,
then the new contact will be connected in parallel to the entire previous contact
connection.
The contact is preset with the text "???". You can click on this text and change it to the
desired variable or the desired constant. For this you can also use the Input Assistant.
For the possibility of entering addresses, of linebreaks for variable names and of
comments per contact or coil please see the description of the Ladder Options dialog.
'Insert' 'Parallel Contact (negated)' in LD
Symbol: Shortcut: <Ctrl> + <D>
This command inserts a negated parallel contact. The same is true as for the
commands 'Insert' 'Parallel Contact' and 'Extras' 'Negate', which in combination also
could be used to insert a negated parallel contact.
'Insert' 'Coil' in LD
Symbol: Shortcut: <Ctrl>+<L>
You can use this command in the LD editor to insert a coil in parallel to the previous
coils.
If the marked position is a connection between the contacts and the coils, then the
new coil will be inserted as the last. If the marked position is a coil, then the new coil
will be inserted directly above it.
The coil is given the text "???" as a default setting. You can click on this text and
change it to the desired variable. For this you can also use the Input Assistant.
For the possibility of entering addresses, of linebreaks for variable names and of
comments per coil please see the description of the Ladder Options dialog.