Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 244)

L-force | PLC Designer
The Individual Components
242 DMS 3.2 EN 02/2011 TD29

6.7 Window set up...
Under the 'Window' menu item you will find all commands for managing the
windows. There are commands both for the automatic set up of your window as well
as for opening the library manager and for changing between open windows. At the
end of the menu you will find a list of all open windows in the sequence they were
opened. You can switch to the desired window by clicking the mouse on the relevant
entry. A check will appear in front of the active window.
6.7.1 'Window' 'Tile Horizontal'
With this command you can arrange all the windows horizontally in the work area so
that they do not overlap and will fill the entire work area.
6.7.2 'Window' 'Tile Vertical'
With this command you can arrange all the windows vertically in the work area so
that they do not overlap and will fill the entire work area.
6.7.3 'Window' 'Cascade'
With this command you can arrange all the windows in the work area in a cascading
fashion, one behind another.
6.7.4 'Window' 'Arrange Symbols'
With this command you can arrange all of the minimized windows in the work area in
a row at the lower end of the work area.
6.7.5 'Window' 'Close All'
With this command you can close all open windows in the work area.
6.7.6 'Window' 'Messages'
Shortcut: <Shift>+<Esc>
With this command you can open or close the message window with the messages
from the last compiling, checking, or comparing procedure.
If the messages window is open, then a check (9) will appear in front of the
command.