LSC Lighting CLARITY LX Series v.1 - Manual (Page 229)

Clarity Scheduler
Operator Manual
Page 219
wireless network. LSC recommends using the “Ethernet 2” port to connect to the wireless router
or a network because Clarity’s default setting for Ethernet 2 is “DHCP”. This allows the router or
network to automatically assign an IP address to Clarity.
Make sure your iPhone/iPad/Android is connected to the same wireless network as Clarity.
On a desktop version of Clarity, navigate to your computers network connections and make a
note of your computers IP Address.
On the LX console, start the LX Tools by pressing Function+Fine+Fine at the same time.
Navigate to the “Networking” screen and make a note of the IP address of the Ethernet connection
to which the wireless network is connected.
On your iPhone/iPad/Android, in the TouchOSC app on the “Connections” pane, select “OSC” and
in the “Host” enter the IP address of Clarity that you noted down above.
On Clarity, from the “Show/Settings/OSC settings” menu open Clarity’s OSC server.
In the OSC Server Pane make the following settings:
 Tick “Enable OSC server”.
 Setup the “Outgoing port:” to match the Incoming port on the iPhone/iPad.
 Setup the “Incoming port:” to match Outgoing the port on the iPhone/iPad.
 “New Clients:”. This can be set to either “Reject”, “Ask” or “Allow”.
If set to “Ask”, then any newly detected OSC client will cause a pop up screen to appear
to confirm the operation. This “pop up” can be bypassed. See below.
If set to “Allow” then it will automatically connect but beware that unwelcome users
might connect without your knowledge.
 “Predefine client IP address:”. If “New Clients:” is set to “Ask” and you enter your
iPhones “Local IP address” then it will bypass the confirmation pop up.
34.2.3 Controlling Clarity with Touch OSC
Run the Touchosc app on your iPhone/iPad/Android.