LSC Lighting CLARITY LX Series v.1 - Manual (Page 76)

LX Console Controls Clarity
Operator Manual
Page 66
Any playback that has been assigned as an “extended playback control” can be changed to any
of the available functions, “Chase Rate”, Playback Rate, “Effects Rate” or “Effects Amplitude”. If
the “Configure playbacks” window is still open (as selected above) select the playback to be
changed by touching its touch screen or use its Select button. If the “Configure playbacks”
window is closed, double tap on the touch screen of the playback to be changed and the
“Configure Playbacks” screen appears.
At the top right of the screen choose either “Chase Rate”, Playback Rate, “Effects Rate” or
“Effects Amplitude”.
The buttons and fader on each of these playbacks (columns), now perform the following
functions:
 Pressing Go or Pause steps the values up or down respectively. If you hold the button it
will auto-repeat after a delay.
 Holding the Flash button when pressing Go or Pause makes them step in larger
increments.
 Pressing both Go and Pause together resets to the default value.
 On fader playbacks, holding the Flash button allows you to use the fader to make fine
adjustments to the value. If you reach a fader end-stop but you need to more range,
you can release the flash button and move the fader to the opposite end, then hold flash
and move fader to continue adjusting the value. This is known as “scooting” the fader.
The user preference “Invert flash button operation on rate faders” changes this
operation so that you just move the fader without holding flash to adjust the value, then
(if you reach the fader end stop) hold flash to reposition the fader. So the fader is
always connected giving you instant control but you can hold the Flash button down to
'scoot' the fader. See section 37.1 for User Preferences.
On LX consoles, the color of the fader contents indicators of any faders set as “extended
playback controls” are “Cyan”. See below for fader contents indicators color codes.
Cue-list
being
controlled
Controls
Chase
Rate
Controls
Playback
Rate
Controls
Effect
Rate
Controls
Effect
Amplitude
Functions for
selected
column