Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 100)

Chapter 3
Offset Tables and Setup
3-28
2. Press the {PRGRAM PARAM} softkey.
(softkey level 2)
PRGRAM
PARAM
AMP DEVICE
SETUP
MONI-
TOR
TIME
PARTS
PTOM
SI/OEM
SYSTEM
TIMING
3. Press the {F1 - F9} softkey to display the single-digit feedrate table.
(softkey level 3)
ZONE
LIMITS
F1-F9
The single-digit feedrate table appears:
REPLCE
VALUE
ADD TO
VALUE
UPDATE
& EXIT
QUIT
ENTER VALUE:
1-DIGIT F WORD FEEDRATE [MMPM]
F1 .01000
F2 .02000
F3 .03000
F4 .04000
F5 .05000
F6 .06000
F7 .07000
F8 .08000
F9 .09000
Important: The control displays feedrates in inch or metric depending on
which is the active mode. The control displays IPM (inches per minute) or
MMPM (millimeters per minute) at the top of the screen, indicating the
currently active mode.