Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 811
9/Series Grinder
Index
Operation and Programming Manual
vii
program, 22-13
request, 22-15
Italian, Language Display, 8-23
J
Japanese, Language Display, 8-23
Jog on the fly, 4-6
Jog Retract, 2-10, 7-27
Jog Select, 2-9
Jogging
arbitrary angle jog, 4-5
continuous jog, 4-3
HPG jog, 4-4
incremental jog, 4-3
jogging an axis, 4-2
Jogging at Rapid (TRVRS), 2-10
jogging, angled-wheel grinders, 14-14
Jogging in auto mode, 4-6
K
Keyboard, 2-3
L
L Word, 10-35
program interrupts, 22-3
Languages, Changing, 8-23
Leading Zero Suppression (LZS), 10-17
Length Offset Table, 3-11
Length offsets for in process dresser, 21-6
Limits
hardware, 11-36
resetting, 11-43
software, 11-36
spindle speed, 12-43
Linear Acc/Dec, 12-65
Linear Interpolation Mode (G01), 12-3
Local Parameters, 20-13
Log, of errors, 2-38
Look Ahead, Block, 15-59
M
M Code Status Display, 8-16
M Codes, 10-29
M00 program stop, 7-17, 10-31, 20-48
M01 optional program stop, 7-17, 10-31
M02 end of program, 10-31
M19 spindle orient, 12-51
M30 end of program with tape rewind, 10-32
M48 Override Enabled, 10-32, 12-58, 12-59
M49 Override Disabled, 10-32, 12-58, 12-59
M58 CSS enable, 10-32, 12-42
M59 CSS disable, 10-33, 12-42
M96 enable program interrupts, 22-2
M97 disable program interrupts, 22-2
M98 subprogram call, 10-13, 10-33
M99 end of main program, 10-33
M99 paramacro return, 10-33
M99 subprogram return, 10-14, 10-33
M Word, 10-29
M-Codes
M03 Primary Spindle Clockwise, 12-74
M04 Primary Spindle Counterclockwise, 12-74
M05 Primary Spindle Stop, 12-74
M19 Primary Spindle Orient, 12-72
M19.2 Aux Spindle 2 Orient, 12-72
M19.3 Aux Spindle 3 Orient, 12-72
M900
M904 dressing interrupts, 22-13
M900 Interrupt retrace blocks, 22-6
Machine Coordinate System, 11-2
motion (G53), 11-3
Machine Information, 8-33
Machine Messages, 2-37
clearing, 2-40
Macro
call commands, 20-48
nesting, 20-57
output commands, 20-59
Main Program Jumps, 10-35
Main Program Sequence Starting #:, 8-31
Main Program Sequence Stopping #:, 8-31
Maintaining in process dresser offsets, 21-6
Manual Data Input Mode, 4-13
Manual Gap Elimination, 4-6
Manual Homing, 4-11