Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 269)

Communications
Chapter 9
9-9
PRGRM NAME -- if set to “yes,” a program name is recognized as the
end of the previous program. The program name must be in one of
these forms where xxxxx indicates an integer from 0 to 99999:
Oxxxxx (ASCII)
:xxxxx (EIA)
Nxxxxx (except for N00000)
Important: If you use an N-code to designate the program name, be aware
that the control interprets all part program blocks that contain N-codes as
new part programs.
If you load a program on a peripheral device, such as a tape reader, and
you want to send a copy of that program to control memory, follow these
steps:
1. Verify that the peripheral device is connected to the correct serial port
and that the port is configured for that device (see page 9-1).
2. Press the {PRGRAM MANAGE} softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
The Program Directory Screen is displayed:
9.2
Inputting Part Programs
from a Serial Peripheral