Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 281)

Introduction to Programming
Chapter 10
10-3
Figure 10.1
Tape Configuration (Program End = M02, M30, M99)
E
R
or
%
E
O
B
Program start code
Leader
section
Tape start
code
E
O
B
Part program
Program
end code
Tape end
code 1 foot
space
E
O
B
O100
Program
name (opt)
O101
Program
name
(opt)
Program
end code
Part program
M30 M99
Comment
(opt)
E
O
B
Comment
(opt)
Program start code
Typical single program tape
E
R
or
%
Typical multi-program tape 12013-I
Tape with Program End = % (ASCII), ER (EIA)
Unlike the previous tape type mentioned, this type of tape accepts only the
“%” (ER) field as the program end code (see Figure 10.2). See this chapter
for details on legal program end codes and the effect of STOP PRG END.
Figure 10.2
Tape Configuration (Program End = % (ASCII), ER (EIA))
ER
or
%
E
O
B
Program start code
Leader
section
Tape start
code
Part program
Program
end code
Tape end
code 1 foot
space
O100
Program
name
(opt)
O101
Program
name (opt) Program
end code
Part program
%
Comment
(opt)
E
O
B
Comment
(opt)
Program start code
ER
or
%
or
ER
%
or
ER
Typical single program tape
Typical multi-program tape 12014-I
This tape format should conform to the variable block length format
specified by EIA standard RS-274D.