Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 84)

Chapter 3
Offset Tables and Setup
3-12
2. Decide if you want to display:
wheel length offset table
or
radius/orientation offset table
(softkey level 2)
WORK
CO-ORD
WHEEL
GEOMET
RADIUS
TABLE
DRESSR
TABLE
SCALNG
COORD
ROTATE
BACKUP
OFFSET
To display: Press this softkey:
wheel length offsets {WHEEL GEOMET}
An example of a wheel length offset table screen
is shown in Figure 3.9.
radius/orientation offsets {RADIUS TABLE}
An example of a radius/orientation offset table
screen is shown in Figure 3.10.
3. Move the cursor to the offset data that you want to modify. The
offset data located at the cursor appears in reverse video.
Important: The softkeys below appear after pressing {WHEEL
GEOMET} on a cylindrical grinder. If you press {RADIUS TABLE}
or if your control is configured as a surface grinder, several of these
softkeys are not available.
(softkey level 3)
SEARCH
NUMBER
REPLCE
VALUE
ADD TO
VALUE
ACTIVE
OFFSET
MORE
OFFSET
MEAS-
URE
INCH/
METRIC
COPY
OFFSET
RADI/
DIAM
If you want to: Press:
move the block cursor to the offset data on the
current page up,down, left, or right cursor keys
change pages {MORE OFFSET} softkey
search all pages for a specific offset number by
keying in the desired offset number and by
pressing the [TRANSMIT] key {SEARCH NUMBER} softkey