Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 258
Displays and Graphics
Chapter 8
8-38
4.
Press the
{ENTER MESAGE}
softkey. This highlights the softkey, and
the control displays the input prompt “PTO MESSAGE:” at the top of
the screen. Also, the current text, if any, of the selected message line
is shown on the input line next to the prompt. (The text may be
edited like any other input string.)
(softkey level 3)
ENTER
MESAGE
STORE
BACKUP
5.
Once the line has been edited, press the
<TRANSMIT>
key. This
transfers the edited line to the PTO screen. After pressing the
<TRANSMIT>
key, you can either:
edit another line
exit the PTO screen by pressing the up arrow softkey
6.
To save changes to the system integrator message lines, press the
{STORE BACKUP}
softkey. When pressed, the softkey will be shown
in reverse video until the control has finished storing the lines.
Important: If the messages are not stored to EEPROM, the text will be
lost the next time the system is powered down.
(softkey level 3)
ENTER
MESAGE
STORE
BACKUP