Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 677)

Paramacros
Chapter 20
20-33
#5600 to 5625
Part Program Block Create Through PAL Display Pages
Use these parameters to assign numeric values to their corresponding
block letter codes during part program block creation through PAL display
pages. They are read or write parameters. Your system installer must
create PAL display pages through which these numeric values must be
entered. When the part program block create through PAL display pages
feature is activated, the control combines the block letter codes and their
assigned numeric values to form a part program block.
5600 A 5613 N
5601 B 5614 O
5602 C 5615 P
5603 D 5616 Q
5604 E 5617 R
5605 F 5618 S
5606 G 5619 T
5607 H 5620 U
5608 I 5621 V
5609 J 5622 W
5610 K 5623 X
5611 L 5624 Y
5612 M 5625 Z
#5630
S- Curve Time per Block
This parameter is read only. The value represents the amount of time
(seconds converted to system scans) for a part program block’s S--Curve filter
where S--Curve Acc/Dec is applied during G47.1 mode. When it is
multiplied by the scan time, the product equals the amount of time required
by the acceleration.
This parameter is only calculated for blocks that have programmed motion
with S--Curve Acc/Dec.