Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 239)

Displays and Graphics
Chapter 8
8-19
{ALL}
This screen provides a multiple display of position information from the
program, distance to go, absolute, and target screen. The all display is
only available on systems with 6 or less axes. On systems with more than
6 axes, other combination screens are available which display a subset of
the data available on the ALL display.
Figure 8.17
Result After Pressing {ALL} Softkey
E-STOP
PROGRAM DISTANCE TO GO [ MM ]
X - 7483.647 X 0.000
Y - 7483.647 Y 0.000
Z - 7483.647 Z 0.000
ABSOLUTE TARGET
X 0.000 X - 7483.647
Y 0.000 Y - 7483.647
Z 0.000 Z - 7483.647
U 0.000 U - 7483.647
F 0.000 MMPM S 0
M CODE PRGRAM
D T G
ALL G CODE
STATUS
The {ALL} selection is not available for more than 6 axes.
Important: If you have more than 6 axes, then you will not have an {ALL}
softkey. A {PRG TAR} and a {PRG ABS} softkey appear.
M CODE
STATUS
PRGRAM
D T G
PRG
TAR
PRG
ABS
G CODE
STATUS