Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 108)

Manual/MDI Operation Modes
Chapter 4
4-4
axis. This includes attempts to perform other incremental moves on
that axis.
The control normally jogs the axes, the selected distance and direction, at
the feedrate set in AMP for the MED feedrate. Your system installer can
select a different feedrate with a specific PAL Program. See
documentation prepared by your system installer for details.
Important: You can jog more than one axis at a time. To jog multiple
axes, press more than one axis direction button. The selected axes drive at
the feedrate chosen under
<SPEED/MULTIPLY> . If the selected feedrate is
above a specific axis maximum allowable feedrate, that axis drives at its
maximum feedrate. The feedrate for the other selected axes is not affected.
This section describes the procedure for jogging an axis using a hand pulse
generator (HPG). We assume that your system is configured for only one
HPG. If your system installer has installed more than one HPG, they may
not function as described here. For details, see documentation provided by
your system installer.
To jog an axis using a hand pulse generator (HPG):
1. Select HANDWHEEL under <JOG SELECT> .
2. Select the distance that the axis moves for one division of the HPG
with
<SPEED/MULTIPLY> . The distance the axis moves per division is
equal to an amount specified in AMP for each selection under
<SPEED/MULTIPLY> .
Important: The x1000 and x10000 selections under
<SPEED/MULTIPLY> are not usable in HPG jog mode.
3. Press the <AXIS/DIRECTION> button for the axis to jog. The direction
the axis moves is determined by the direction the HPG is rotated and
is unaffected by the
<AXIS/DIRECTION> button.
Important: You can jog more than one axis at a time using the HPG
if your system installer has written PAL to allow it. See
documentation prepared by your system installer for details.
4.1.4
HPG Jog