Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 107)

Manual/MDI Operation Modes
Chapter 4
4-3
During a jog retract operation (see chapter 7), you are permitted to use
only normal single axis jogs (one axis at a time in the continuous,
incremental, or HPG modes).
To jog an axis continuously:
1. Select CONTINUOUS under <JOG SELECT> .
2. Select the feedrate for continuous jog under <SPEED/MULTIPLY> .
If you want to: Then:
alter the feedrate selected with the
<SPEED/MULTIPLY> switch select a <FEEDRATE OVERRIDE> %
jog the axis at a special AMP assigned
traverse feedrate and ignore the setting of
the <SPEED/MULTIPLY> switch press and hold the <TRVRS> when jogging
jog moves that use the traverse feedrate select a <RAPID FEEDRATE
OVERRIDE> %
For details on using the feedrate override switches, see chapter 11.
3. Press the <AXIS/DIRECTION> button for the axis and direction to jog.
The axis moves while the button is held down.
Important: You can jog more than one axis at a time. To jog
multiple axes, press and hold more than one axis direction button.
The selected axes drive at the feedrate chosen with the
<SPEED/MULTIPLY> switch. If the selected feedrate is above a
specific axis maximum allowable feedrate, that axis drives at its
maximum feedrate. The feedrate for the other selected axes is not
affected.
Incremental jog manually moves an axis a predetermined amount each
time you press the
<AXIS DIRECTION> button. To use incremental jog:
1. Select INCREMENTAL under <JOG SELECT> .
2. Select the jog increment under <SPEED/MULTIPLY> . The jog
increment is equal to an amount specified in AMP for each selection
under
<SPEED/MULTIPLY> .
3. Press the <AXIS/DIRECTION> button for the axis and direction to jog.
The control makes one incremental move each time it recognizes the
<AXIS/DIRECTION> button. Until the control completes the execution
of the incremental move, no other jog moves are recognized on that
4.1.2
Continuous Jog
4.1.3
Incremental Jog