Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 274)

Communications
Chapter 9
9-14
3. Press the {COPY PRGRAM} softkey.
(softkey level 2)
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERIFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
REFORM
MEMORY
CHANGE
DIR
4. Enter the program name to output from memory. Two ways to do this
are available:
Type in the program name using the alphanumeric keys on the
keyboard. The control displays program name on the input line
(line 2 of the screen) next to the prompt “FILENAME”.
Use the up and down cursor keys to position the cursor at the
program you want to send. The selected program appears in
reverse video.
If outputting all programs, cursor to the first program in your
program directory.
5. Select the device you want to copy as follows:
If the peripheral device is connected to: Press this softkey:
Port A {MEM TO PORT A}
Port B {MEM TO PORT B}
(softkey level 3)
MEM TO
PORT A
FROM A
TO MEM
MEM TO
PORT B
FROM B
TO MEM
MEM TO
MEM
The copy parameters screen appears (see Figure 9.4).
6. Specify if you want to output one, multiple, or all programs onto tape.
Output Single Program
Press {SINGLE PRGRAM} to output the program selected in
step 4.