Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 807)

9/Series Grinder
Index
Operation and Programming Manual
iii
D
D Word, 22-10
Date, setting, 2-44
Deceleration, 12-63
Decitek AB 8000-XPDR, 9-4
Deleting a Program, 5-37
Determining the wheel angle, 14-2
Diameter Mode (G08), 11-46
Digitizing a Program, 5-28
arc (3 points), 5-33
arc tangent at end points, 5-35
linear, 5-31
Directory
main, 5-2
protectable, 5-2
Display Pages, PAL, 8-22
Display Select, 8-1
Displaying, S Word, 12-44
Displaying a Program {DISPLY PRGRAM}, 5-39
Displaying Machine Information, 8-33
Displaying Position
ABS, 8-6
ABS (Large Display), 8-7
absolute (Small Display), 8-8
ALL, 8-19
distance to go (Small Display), 8-14
DTG, 8-12
DTG (Large Display), 8-13
G Code Status, 8-20
M Code Status, 8-16
PRGRAM, 8-3
PRGRAM (Large Display), 8-4
PRGRAM (Small Display), 8-5
PRGRAM DTG, 8-17
program/DTG (Small Display), 8-18
Target, 8-9
Target (Large Display), 8-10
target (Small Display), 8-11
Distance to Go Position Display, 8-12
Dither, 17-21, 17-24
Downloading Part Programs from ODS, 6-6
Dresser
activating, 21-7
parameters, 21-8
Dresser Amount Per Rev, 21-10
Dresser Hold, 21-9
Dresser Retract Distance, 21-10
Dresser Roll Diameter, 21-9
Dresser Surface Speed Ratio, 21-10
Dresser, see In process dresser, 21-1
Dresser/Wheel Radius Compensation
block generation, (G39, G39.1), 15-15
block look ahead, 15-59
cancel (G40), 15-5
circular transition (G39.1), 15-15
corner movement after generated blocks, 15-49
cutter radius changes, 15-51
direction changes, 15-42
entry moves
type A, 15-17
type B, 15-27
error detection, 15-60
disabling, 15-62
exit moves
type A, 15-20
type B, 15-30
G Codes
cancel (G40), 15-5
circular transition (G39.1), 15-16
G41, G42, 15-62
left (G41), 15-5
linear transition (G39), 15-16
right (G42), 15-5
grinding wheel path, 15-37
left (G41), 15-5
linear transition (G39), 15-15
machine home (to/from), 15-57
MDI or manual motion, 15-55
minimum block length, 15-16
non motion blocks, 15-46
overview, 15-1
programming instruction, 15-5
right (G42), 15-5
setup buffers, 15-59
special cases, 15-42
type A, overview, 15-3
type B, overview, 15-3
work coordinate system, offsetting, 15-58
Dressing
program, 16-12, 17-10
tool radius, 3-6
with CSS active, 12-36, 12-40
Dressing Axis for in process dressing, 21-1
Dressing Interrupts
auto dress, 22-10