Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 92)

Chapter 3
Offset Tables and Setup
3-20
Figure 3.11
Work Coordinate System Data Entry
REPLCE
VALUE
ADD TO
VALUE
INCH/
METRIC
RADI/
DIAM
MORE
OFFSET
WORK COORDINATES TABLE PAGE 1 OF 4
DIAMOND 1 DIAMOND 2 CHUCK 1
G54 [INCH] G55 [ MM ] G56 [ MM ]
R X -999.9999 X -999.9999 X -999.9999
Z -999.9999 Z -999.9999 Z -999.9999
3. Move the cursor to the offset data you want to modify. The data
located at the cursor appears in reverse video.
If you want to: Press:
move the block cursor to the offset data on the
current page up, down, left, or right cursor key
change pages {MORE OFFSET} softkey