The programmable zone table appears – Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 98
Advertising
Chapter 3
Offset Tables and Setup
3-26
3.
Press the {ZONE LIMITS} softkey to display the programmable
zone table.
(softkey level 3)
ZONE
LIMITS
F1-F9
The programmable zone table appears:
REPLCE
VALUE
ADD TO
VALUE
UPDATE
& EXIT
QUIT
ENTER VALUE:
PROGRAMMABLE ZONE
LOWER LIMIT
UPPER LIMIT
LIMIT 2
R X
AXIS
-10.0000
0.0000
[INCH]
Z
AXIS
0.0000
0.0000
[INCH]
LIMIT 3
R X
AXIS
5.0000
9.0000
[INCH]
Z
AXIS
3.0000
4.0000
[INCH]
Important: The control displays the programmable zone coordinates in
inch or metric units for a liner axis, depending on which is the currently
active program mode, or in degree units for a rotary axis.
4.
Use the up and down cursor keys to move the block cursor to the data
you want to change. The data located at the cursor appears in reverse
video.
Advertising